Operation CHARM: Car repair manuals for everyone.

P0403






P0403 - EGR CONTROL CIRCUIT





When Monitored and Set Condition

- When Monitored: A constant engine speed between 900 and 1700 RPM and no other EGR or MAP sensor faults.
- Set Condition: The PCM commands the EGR valve to open. The MAP sensor value must drop by a minimum of 54 mbar (1.6 in Hg) when EGR is commanded open or a fault is set.







Diagnostic Test

1. CHECK FOR CURRENT DTC





Turn the ignition on.

With the DRB III(R), read PCM DTCs.

Is this DTC present?

Yes

- For complete diagnosis of this DTC, refer to (P0400) EGR SYSTEM PERFORMANCE. P0400

No

- Go To 2

2. INTERMITTENT WIRING AND CONNECTORS

The conditions necessary to set this DTC are not present at this time.

NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.
Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.

NOTE: Check for any Technical Service Bulletins that may apply.

Were there any problems found?

Yes

- Repair as necessary.