Operation CHARM: Car repair manuals for everyone.

ABS Right Front Sensor Message






P0600 - ABS RIGHT FRONT SENSOR MESSAGE





When Monitored and Set Condition

- When Monitored: Valid ABS CAN messages received at least once and the CAN BUS Circuit, ABS CAN Message Missing, ABS CAN Message Incorrect are not active.
- Set Condition: Wheel Speed Front Right signal not valid or CAB has detected a sensor failure.






Diagnostic Test


1. PRE-DIAGNOSTIC CHECK OUT





NOTE: Low fluid level can be the cause of many transmission problems. If the fluid level is low, locate and repair the leak then check and adjust the fluid level.

NOTE: Always perform diagnostics with a fully charged battery to avoid false symptoms.

With the DRB III(R), read Engine DTCs. Check and repair all engine DTCs prior to performing transmission symptom diagnostics.

With the DRB III(R), read and record all Transmission DTCs.


NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs.

Using the wiring diagram/schematic as a guide, inspect the wiring and connectors. Repair as necessary.

Most DTCs set on start up but some must be set by driving the vehicle such that all diagnostic monitors have run.


NOTE: Check for any Technical Service Bulletins that may apply.

Perform this procedure prior to Symptom diagnosis.

Continue

Go To 2



2. (P0720) CAN BUS CIRCUIT DTC PRESENT





Turn the ignition on.

With the DRB III(R), read Transmission DTCs.


NOTE: If DTC (P0720) CAN BUS CIRCUIT is present, perform diagnostics on that symptom first. P0720

Is DTC (P0720) CAN BUS CIRCUIT present?

Yes

- Refer to the Transmission and Drivetrain and perform the appropriate symptom.

No

Go To 3



3. CHECK TO SEE IF ABS DTCS ARE PRESENT





With the ignition on.

With the DRB III(R), read ABS DTCs.

Are any ABS DTCs present?

Yes

- Refer to the Brakes and Traction Control/Testing and Inspection and perform the appropriate symptom.

No

Go To 4



4. CONTROLLER ANTILOCK BRAKE





Turn the ignition off.

Replace the Controller Antilock Brake.

Turn the ignition on.

With the DRB III(R), erase Transmission DTCs.

Road test the vehicle.

With the DRB III(R), read Transmission DTCs.

Did DTC (P0600) ABS RIGHT FRONT SENSOR MESSAGE set again?

Yes

- Replace the Transmission Control Module.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Transmission Verification Test

No

- Test Complete.