3-4 Solenoid Circuit Short To Ground

P0763 - 3-4 SOLENOID CIRCUIT SHORT TO GROUND





When Monitored and Set Condition

- When Monitored: Always monitored with system active at each ignition cycle.
- Set Condition: If the TCM detects a short to ground on the solenoid control circuit or a solenoid control circuit shorted to ground in the TCM.






Diagnostic Test


1. CHECK FOR CURRENT DTC





Turn the ignition on.

With the DRB III(R), read Transmission DTCs.

Is this DTC present?

Yes

- For complete diagnosis of this DTC, refer to (P0763) 3-4 SOLENOID CIRCUIT. 3-4 Solenoid Circuit

No

- Go To 2



2. INTERMITTENT WIRING AND CONNECTORS

The conditions necessary to set this DTC are not present at this time.


NOTE: Check connectors - Clean/repair as necessary. Poor pin to terminal connections can set DTCs. Using the wiring diagram/schematic as a guide, inspect the wiring and connectors specific to this DTC. Wiggle the wires while checking for shorts and open circuits.


NOTE: Check for any Technical Service Bulletins that may apply.

Were there any problems found?

Yes

- Repair as necessary.
- Perform NAG1 TRANSMISSION VERIFICATION TEST. Transmission Verification Test

No

- The condition that caused this DTC to set is currently not present. Inspect the related wiring harness for a possible intermittent condition.