Programming and Relearning

STANDARD PROCEDURE - UNIVERSAL TRANSMITTER PROGRAMMING

ERASING CODES

To erase previously programmed Garage Door Opener codes, simply hold down the two outside buttons until the red LED begins to flash.

PROGRAMMING CODES

1. Turn the ignition ON.

2. Erase the factory test codes by pressing the two outside buttons on the Universal Garage Door Opener. Release the buttons when the red light begins to flash.

3. Choose one of the three buttons on the vehicles Universal Garage Door Opener to program.

4. Place the manufacturer's hand-held transmitter within one inch of the vehicles Universal Garage Door Opener.

5. Simultaneously push the buttons on both the transmitters (the manufacturers transmitter will transmit a signal, and the Universal Garage Door Opener will receive the signal).

6. The red light on the Universal Garage Door Opener will begin to flash slowly (slowly flashing light indicates data is being transmitted).

7. When the red light on the Universal Garage Door Opener begins to flash rapidly (this may take as long as 60 seconds), release both buttons (rapidly flashing light indicates the data transmission is complete).

8. The Universal Garage Door Opener is now programmed. Advise the vehicle owner to be sure to keep the manufacturer's hand-held transmitter in case it is needed to reprogram the Universal Garage Door Opener.