Programming and Relearning

TOGGLING CUSTOMER PREFERENCES

Automatic Locking

The automatic locking function can be activated or deactivated with the DRB III(R). The interior power door lock switch may also be used with the ignition switched on by pressing and holding the power door lock switch for more than 5 seconds in either the lock (auto locking switched on) or unlock (auto locking switched off) position. The interior power door lock switch can be inhibited with the DRB III(R).

Global/Selective Central Locking

The keyless entry system has a Global or Selective mode function for central locking that can be programed by the customer. The factory setting is Global, which will lock and unlock both doors, rear liftgate and fuel door centrally when the respective button is pressed once. The Selective mode will only change which power locks unlock. To activate the Selective mode, press both the Unlock and Lock buttons simultaneously for approximately five seconds until the battery check lamp in the transmitter flashes twice. The Unlock button will then only unlock the driver door and the fuel door when it is pressed once. Pressing the Unlock button a second time, unlocks the passenger's door and the rear liftgate. The factory setting can be restored by pressing both the Unlock and Lock buttons simultaneously again for approximately five seconds until the battery check lamp in the transmitter flashes twice. If the vehicle was locked using the power lock switch in the center console while in the Selective mode, opening a door from inside unlocks that door only. If the vehicle was locked using the power lock switch in the center console while in the Global mode, opening a door from the inside unlocks both doors and the rear liftgate. If the vehicle was locked using the RKE transmitter, the doors and rear liftgate cannot be unlocked using the power lock switch in the center console. If the vehicle was locked from the outside, opening a door from the inside will not unlock other openings but it will trigger the alarm.