Hydraulic Pump Motor

HYDRAULIC PUMP MOTOR




1. Connect the hydraulic lines and retaining plate (2) to the pump assembly (3). Torque the bolts (1) to 10 Nm (89 in. lbs.) using Loctite 270.




2. Position the hydraulic pump assembly on the mounting studs in the trunk well. Install the retaining nuts (3). Torque the nuts to 8.5 Nm (75 in. lbs.).

3. Connect the tonneau cover hydraulic cylinder to the tonneau cover hinge (1).

4. Connect the power top hydraulic assembly harness connector (1).

5. Install the power top control module.

6. Install the left trunk trim panel.

7. Connect the negative battery cable.