A/C Performance Test

A/C PERFORMANCE





The Air Conditioning System is designed to provide the passenger compartment with low temperature and low humidity air. The Evaporator (6), located in the HVAC housing behind the Instrument Panel, is cooled to temperatures near the freezing point. As warm damp air passes through the cooled Evaporator (6), the air transfers its heat to the refrigerant in the Evaporator (6) and the moisture in the air condenses on the Evaporator fins.

Humidity has an important bearing on the temperature of the air delivered to the interior of the vehicle. It is important to understand the effect that humidity has on the performance of the Air Conditioning System. When humidity is high, the evaporator has to perform a double duty. It must lower the air temperature, and it must lower the temperature of the moisture in the air that condenses on the evaporator fins. Condensing the moisture in the air transfers heat energy into the Evaporator fins and tubing. This reduces the amount of heat the Evaporator can absorb from the air. High humidity greatly reduces the ability of the Evaporator to lower the temperature of the air.

However, Evaporator capacity used to reduce the amount of moisture in the air is not wasted. Wringing some of the moisture out of the air entering the vehicle adds to the comfort of the passengers. Although, an owner may expect too much from their Air Conditioning System on humid days. A performance test is the best way to determine whether the system is performing up to standard. This test also provides valuable clues as to the possible cause of trouble with the Air Conditioning System.

The air temperature in the test room and in the vehicle must be a minimum of 21° C (70° F) for this test.





1. Connect a manifold gauge set.

2. Set the A/C Heater mode control switch knob (2) in the Panel position, the temperature control knob (7) in the full cool position, the A/C button in the On position, and the blower motor switch knob (6) in the highest speed position.

3. Start the engine and hold the idle at 1,300 rpm with the compressor clutch engaged.

4. The engine should be at operating temperature. The doors and windows must be open.

5. Insert a thermometer in the driver side center A/C (panel) outlet. Operate the engine for five minutes.

6. The compressor clutch may cycle, depending upon the ambient temperature and humidity.

7. With the compressor clutch engaged, record the discharge air temperature and the compressor discharge pressure.

8. Compare the discharge air temperature to the Performance Temperature and Pressure chart.





9. Compare the compressor discharge pressure to the Performance Temperature and Pressure chart. If the compressor discharge pressure is high, see the Pressure Diagnosis chart.