Brake Warning Indicator Inoperative

*BRAKE WARNING INDICATOR INOPERATIVE









Diagnostic Test

1. BRAKE WARNING INDICATOR SWITCH





Turn the ignition off.

Disconnect the Brake Fluid Level Switch harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Connect a jumper wire between cavity 1 and cavity 2 of the Brake Fluid Level Switch harness connector.

Turn the ignition on.

Is the Brake Warning Indicator lamp on?

Yes

- Replace the Brake Fluid Level Switch.
- Perform BODY VERIFICATION TEST. Body Verification Test

No

- Go to 2

2. MEASURE BRAKE WARNING INDICATOR CIRCUIT RESISTANCE





Turn the ignition off.

Disconnect the Instrument Cluster C1 harness connector.

NOTE: Check connectors - Clean/repair as necessary.

Connect a jumper wire between cavity 1 and cavity 2 of the Brake Fluid Level Switch harness connector.

Measure the resistance between ground and the Brake Warning Indicator circuit.

Is the resistance below 5.0 ohms?

Yes

- Check the Brake Warning Indicator lamp. If the lamp is OK, replace the Instrument Cluster.
- Perform BODY VERIFICATION TEST. Body Verification Test

No

- Repair the Brake Warning Indicator circuit for an open.
- Perform BODY VERIFICATION TEST. Body Verification Test