Occupant Restraint Controller - Removal

REMOVAL

WARNING: On vehicles equipped with airbags, disable the supplemental restraint system before attempting any steering wheel, steering column, driver airbag, passenger airbag, front impact sensor, side impact sensor, side impact airbag, or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the supplemental restraint system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury.

WARNING: The occupant restraint controller contains the impact sensor, which enables the system to deploy the supplemental restraints. Never strike or drop the occupant restraint controller, as it can damage the impact sensor or affect its calibration. If an occupant restraint controller is accidentally dropped during service, the module must be scrapped and replaced with a new unit. Failure to observe this warning could result in accidental, incomplete, or improper supplemental restraint deployment and possible occupant injuries.





1. Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.





2. Remove the center console.

3. Disconnect the occupant restraint controller harness connector (2).

4. Remove the bolts (1) attaching the occupant restraint controller to the transmission tunnel.

5. Remove the occupant restraint controller from the vehicle.