Front Door Window Glass: Adjustments

ADJUSTMENT - DOOR GLASS




1. Check the front door adjustment and adjust if necessary.

2. Remove the door trim panel on the front door.

3. Remove the door speaker (1).

4. Remove the door foil from the door.

5. Loosen the nuts from both of the window stop brackets (2-4) located in the middle portion of the door.

6. Close the window (5) until it is flush with the front edge of the door escutcheon.




7. Remove the plug on the underside of the door (2) covering the bolt (3), loosen the bolt until the guide rail can be moved.

NOTE: In the second detent stage of the door lock, the edge of the window glass must disappear completely below the rubber seal. If necessary, the inclination of the window can be corrected by loosening the bolts, and the longitudinal direction of the window can be corrected by loosening the bolt. In addition, the inclination of the window relative to the weatherstrip can be increased or reduced by loosening the nut, the sliding jaw must be moved for this purpose.

8. Adjust the window so that the upper glass edge makes contact with the inner rubber sealing lip (1) over the entire length when the door lock is in the first catch position, then tighten bolts and nuts (3) on the guide rail.

9. Tighten the bolts and nut if they were loosened.

10. Install the bolt plug.

NOTE: Grease the sliding jaws and guide rail as well as the window lift rail.

11. Check the window for ease of movement.

12. Install door foil on the door.

13. Install the door speaker.

14. Install the door trim panel on the front door.