Removal
REMOVAL
WARNING: WHEN WORKING ON THE POWER WINDOWS OR THE WINDOWS IN THE VEHICLE DOORS, THE UNSECURED WINDOW CAN FALL DOWN AND CAN CAUSE INJURY BY PINCHING HANDS.
CAUTION: Secure the window against falling down.
1. Remove the door trim panel. Refer to Trim Panel.
NOTE: Move the plastic wedge directly into the clips.
2. Remove the inner window sealing rail by opening the window, then press the sealing rail off of the inner door with a plastic wedge and remove from the door. Check the clips for wear or damage (5 each).
3. Remove the outer window sealing rail by removing the two chrome cover screws (1), then pull the rubber door seal off at the separation point which is about 3-4 inches down the back of the door seal.
4. Remove the cover on the door escutcheon with a plastic wedge, then remove the expanding anchor clip.
5. Press the sealing rail off of the window shaft uniformly with a wedge and remove from the door.
6. Remove the door speakers by removing the screws (1).
7. Remove the door foil from the inner door.
8. Lower the window until the mounting screws (2-4) are accessible through the assembly openings in the door.
9. Disconnect the connector for the power window motor (3).
NOTE: The slider is fastened to the window and cannot be removed.
10. Loosen the mounting bolt only until the window (5) can be lifted out of the slider.
11. Remove the window by pulling it upward while guiding the slider through the opening in the door shaft.
12. Put the window down on a secure and dry surface.