Removal

REMOVAL

WARNING: DO NOT OPERATE THE VEHICLE WITHIN 24 HOURS OF BACKLIGHT INSTALLATION. IT TAKES AT LEAST 24 HOURS FOR URETHANE ADHESIVE TO CURE. IF IT IS NOT CURED, THE BACKLIGHT MAY NOT PERFORM PROPERLY IN AN ACCIDENT. BE SURE TO REFER TO THE URETHANE MANUFACTURER'S DIRECTIONS FOR CURING TIME SPECIFICATIONS, AND DO NOT USE ADHESIVE AFTER ITS EXPIRATION DATE.


CAUTION: Open a window before installing the backlight to avoid pressurizing the passenger compartment if a door is slammed before the urethane bonding is fully cured, water leaks can result.






Refer to the Windshield Removal procedure for a description of tools and adhesive systems that are recommended for use in this procedure.

1. Remove liftgate trim panels. Refer to Trim Panel.

2. Disconnect wire connectors (3) from rear window defogger (2).

3. Disconnect and remove CHMSL lamp.

WARNING: WEAR EYE AND HAND PROTECTION WHEN HANDLING GLASS. PERSONAL INJURY CAN RESULT.


CAUTION: Do not damage body or trim finish when cutting out glass or applying fence primer.

4. Cut the urethane (1) around the perimeter of the backlight glass. Refer to Windshield for proper procedures.

5. Remove the backlight from the vehicle (4).

6. Prepare the work area, window fence, and glass the same way as described in the Windshield Installation procedure.