2 Wheel Drive

1. Remove drain plug and allow differential to drain.
2. Support differential assembly using a suitable jack.
3. Remove driveshafts and inner shaft.
4. Place alignment marks on pinion flange and driveshaft, then remove driveshaft.
5. Remove lefthand differential support bracket, then disconnect righthand mounting bracket from side frame.
6. Remove front suspension crossmember support bracket from side frame, then remove differential and crossmember as an assembly.
7. Remove differential assembly from crossmember, then remove housing and tube and cover from differential.
8. Reverse procedure to install. Torque differential to housing tube assembly to 58-72 ft. lbs., differential carrier to bracket to 58-72 ft. lbs., front suspension crossmember to 73-86 ft. lbs. and differential mounting brackets to 58-80 ft. lbs.