Manual Transmission/Transaxle: Service and Repair

Fig. 9 Removing anti-rotational link:

1. Disconnect battery ground cable.
2. Raise and support vehicle, then install suitable engine support fixture.
3. Disconnect gearshift linkage and clutch cable from transaxle.
4. Remove front wheel and tire assemblies.
5. Remove left front splash shield, then the left engine mount from transaxle.
6. Disconnect driveshafts. Refer to "Driveshaft, Replace" procedure under "Front Suspension & Steering Section."
7. Support transaxle and remove upper clutch housing attaching bolts.
8. Remove anti-rotational link.
9. Pry transaxle rearward until mainshaft clears clutch, then lower transaxle from vehicle.
10. Reverse procedure to install. When installing left engine mount, refer to "Engine Mounts" procedure.