Window Glass: Service and Repair
Door Waterdam:
Door Trim Panel:
Door Access Panel:
VENT WINDOW REMOVAL
1. Remove the door trim panel (or, if applicable, the access panel) and the waterdam.
Vent Window:
2. Remove the vent window adjusting rod nut.
3. Remove the window frame front retaining screw located under door weatherstrip.
4. Remove one beltline weatherstrip seal.
5. Lower the window glass to the full open position.
6. Close the vent window, tilt it rearward and lift it out of the door opening.
INSTALLATION
1. Tilt the vent window rearward and position it in the door opening.
2. Raise the window glass to the full closed position.
3. Install the beltline weatherstrip seal.
4. Install the window frame front retaining screw.
5. Install the vent window adjusting rod nut.
6. Test the vent window operation. Adjust the window with the adjusting rod, if necessary.
7. Install the door waterdam and the trim panel, or, if applicable, the access panel.
VENT WINDOW GLASS REMOVAL
1. Remove the vent window. If necessary, refer to the removal procedure.
Window Components:
2. Remove the retaining screw from the glass lower pivot.
3. Remove the glass upper pivot fastener and remove the glass from the vent window frame.
INSTALLATION
1. Lubricate the glass lower pivot with Lubriplate, or an equivalent lubricant.
2. Install the glass lower pivot in the glass frame.
3. Install the glass upper pivot.
4. Install the vent window.