Power Window Regulator Replacement

POWER WINDOW GLASS REGULATOR REMOVAL
1. Remove the door trim panel and the waterdam.
2. Open the window glass (move the glass down into the door).

Vent Window:

3. Remove the vent window. If necessary, refer to the removal procedure.
4. Slide the glass forward until the channel separates from the window regulator arm roller.
5. Lower the glass and channel to the bottom of the door.

Power Window Glass Regulator:

6. Remove the center of the regulator retaining rivets with a drift punch and then drill them out with a 6 mm (1/4 in) diameter drill bit. When installed, the regulator should be retained on the door inner panel with 1/4-20 x 1/2 bolts and nuts.
7. Disconnect the regulator motor wire harness connector.
8. Remove the power regulator from the door.

INSTALLATION
1. Position the power regulator in the door and retain it on the inner door panel with 1/4-20 x 1/2 bolts and nuts. Tighten the nuts with 10 Nm (90 in. lbs.) torque.
2. Connect the regulator motor wire harness connector.
3. Raise the glass, slide it rearward and engage the channel with the regulator arm roller.
4. Install the vent window.
5. Test the window glass and regulator operation. Correct as necessary.
6. Install the door waterdam and the trim panel.