Wiper Motor Runs Slowly at All Speeds

Fig. 4 Wiper motor terminal locations. All 1985-87 models:

Fig. 2 Two Speed Wiper Motor Terminal Locations:

1. Remove wiper motor electrical connector from motor, then remove wiper arms and blades.
2. Connect an ammeter between battery and terminal 3 or L.
3. If motor runs and ammeter reading is more than six amps, proceed as follows:
a. Inspect wiper linkage and pivots for binding, then disconnect drive link from motor.
b. If motor now runs and draws less than three amps, repair linkage system.
c. If motor continues to draw more than three amps, replace motor.
4. If motor runs and ammeter reading is less than six amps, proceed as follows:
a. Connect a voltmeter between motor ground strap and terminal 4 or H, then set wiper switch to Low position.
b. If voltage is present, there is a short in the wiring or wiper switch.
c. If voltage is present, set wiper switch to High position, then move voltmeter test lead from terminal 4 or H to 3 or L.
d. If voltage is present, there is a short in the wiring or wiper switch.