Kelsey-Hayes Single Pin Caliper

For additional information see Installation Notes. Fundamentals and Basics

Single Pin Disc Brake Caliper:

1. Push piston back into cylinder bore with uniform pressure until it is bottomed.

Removing Or Installing Inboard Shoe Assembly:

Removing Or Installing Brake Disc:

2. Position inboard pad on adapter.

Fig 2 Marking Brake Disc And Wheel Stud For Reassembly:

3. Slide brake disc assembly on drive flange studs. Pay attention to marks for assembly.
4. Clean both sides of braking disc with alcohol or suitable solvent.

Removing Or Installing Outboard Shoe:

Removing Or Installing Caliper:

5. While holding outboard pad in position on adapter, carefully position caliper over disc brake rotor.
6. Lower caliper over rotor and adapter.
7. Install guide pin through bushing caliper and adapter.

Removing Or Installing Guide Pin:

8. Press in on guide pin and thread pin into adapter. Torque pin to 25-35 ft lb.
9. Install wheel and tire assembly, then lower vehicle.