Replaceable Bearings

REMOVAL

Fig. 14 Hub removal:

Fig. 12 Removing bearing from knuckle:

1. Remove steering knuckle as previously described.
2. Remove hub using tool No. C-4811-14 or equivalent.
3. Remove four bearing retainer to knuckle attaching screws, then the bearing retainer.
4. Pry bearing seal from machined recess in knuckle assembly.
5. Remove bearing from knuckle using tool No. C-4811-2 or equivalent.

INSTALLATION

Fig. 13 Installing bearing into knuckle:

Fig. 14 Installing hub into knuckle:

1. Press new bearing into knuckle using tool No. C-4811-4 or equivalent.
2. Install bearing retainer. Tighten retainer attaching screws to specifications.
3. Press hub into bearing using tool No. C-4811-11 or equivalent.
4. Position new seal in recess, then install using oil seal installer tool No. C-4698 or equivalent.
5. Install steering knuckle refer to STEERING KNUCKLE.