NS-14A Fault Code 11 Distributor Reference Pick-Up

COMPLETE NO START TEST 12-STEP A BEFORE PROCEEDING.
1. With ignition switch Off, disconnect distributor pickup coil connector.
2. Remove coil wire from distributor and place it 1/4 inch from a good engine ground.
3. Turn ignition switch to the Run position, then connect a jumper wire between the gray/black wire and the black/light blue wire of the distributor harness connector.
4. Make and break this connection several times while observing coil wire.
5. If there is spark at the coil wire, proceed to Step B.
6. If there is no spark at the coil wire, proceed to Step D.