Choke Rod Fast Idle Cam (Angle Gauge Method)

Choke Rod Fast Idle Cam Adjustment:

1. Attach a rubber band to the green tang of the intermediate choke shaft as shown, and open the throttle to allow the choke valve to close.
2. Set up the angle gauge and set the angle to 20 degrees, refer to CHOKE VALVE ANGLE GAUGE SET-UP.
3. Place the cam follower on the second highest step of the cam against the rise of the high step. If the cam follower does not contact the cam, turn in the fast idle screw until it does.
4. Make the adjustment by bending the tang of the fast idle cam until the bubble is centered.
5. Remove the angle gauge.