DR-10A Fault Code 32-EGR System

Complete Driveability Test 1-Step A, before proceeding.
1. Connect diagnostic readout box to engine harness connector.
2. Connect a voltmeter between gray/yellow wire of engine harness female 8-way connector and ground, then enter system into ATM Test Mode 13.
3. If voltmeter reads battery voltage, proceed to Step B.
4. If voltmeter indicates no voltage, proceed to Step C.
5. If voltmeter fluctuates between battery voltage and one volt and the solenoid does not click, replace EGR solenoid.
6. On models equipped with SMEC part No. 4379911 only, if voltmeter fluctuates between battery voltage and one volt and the solenoid clicks, proceed to Step F.