120000 MI or 192000 KM
LubricateUniversal Joint, Drive/Propeller Shaft
Lubricate front axle drive joint and spindle pivot bearings.
Steering
Spindle
With 44F-BJ & 60F front differentials. Inspect and lubricate front spindle needle bearings. Also service when replacing disc pads.
Drive/Propeller Shaft
Body and Frame
Lubricate body & brake actuating mechanisms.
Ball Joint
Check
Brakes and Traction Control
Inspect brake linings.
Inspect
Vacuum Harness HVAC
Inspect all vacuum operated emission components and replace as necessary.
Power Steering Fluid
Inspect fluid level. CB & MB 350 models require Hydroboost Power Steering Fluid.
Ignition Timing
Inspect and adjust ignition timing.
Heating and Air Conditioning
Fuel Delivery and Air Induction
Inspect air intake hoses.
Exhaust System
Differential Assembly
Check for leaks.
Crankcase Filter
Clean/oil crankcase inlet air filter.
Cooling System
Clutch Fluid
Inspect fluid level.
Carburetor
Inspect and clean carburetor choke shaft, fast idle cam & pivots. Inspect and clean carburetor choke shaft, fast idle cam & pivots. Also inspect carb heat source.
Brake Hose/Line
Brake Fluid
Inspect fluid level.
Air Injection
If equipped.
Replace
Spark Plug
Positive Crankcase Ventilation Valve
Except California emissions
Positive Crankcase Ventilation Valve
California emissions
Oil Filter, Engine
Ignition Rotor
Ignition Cable
Fluid - A/T
Change fluid and filter, adjust bands.
Engine Oil
If your mileage is less than 7,500 miles (12,000 km) yearly, replace the engine oil filter at each oil change.
Distributor Cap
Air Injection Filter
Air Filter Element
Also clean air filter wrapper (if equipped).
Clean/Repack
Wheel Bearing
Inspect and lubricate front wheel bearings. Also service when replacing disc pads. Clean and repack front spindle needle bearings.
Service or Charge
Transfer Case
Change lubricant.
Manual Transmission/Transaxle
Change lubricant.