60000 MI or 96000 KM

Lubricate
    Universal Joint, Drive/Propeller Shaft
      Lubricate front axle drive joint and spindle pivot bearings.
    Steering
    Drive/Propeller Shaft
    Body and Frame
      Lubricate body & brake actuating mechanisms.
Inspect
    Vacuum Harness HVAC
      Inspect all vacuum operated emission components and replace as necessary.
    Power Steering Fluid
      Inspect fluid level. CB & MB 350 models require Hydroboost Power Steering Fluid.
    Ignition Timing
      Inspect and adjust ignition timing.
    Heating and Air Conditioning
    Fuel Delivery and Air Induction
      Inspect air intake hoses.
    Fluid - A/T
      Check fluid level.
    Exhaust System
    Differential Assembly
      Check for leaks.
    Cooling System
    Clutch Fluid
      Inspect fluid level.
    Carburetor
      Inspect and clean carburetor choke shaft, fast idle cam & pivots. Inspect and clean carburetor choke shaft, fast idle cam & pivots. Also inspect carb heat source.
    Brake Hose/Line
    Brake Fluid
      Inspect fluid level.
    Air Injection
      If equipped.
Replace
    Spark Plug
    Positive Crankcase Ventilation Valve
      Except California emissions
    Oil Filter, Engine
    Ignition Rotor
    Ignition Cable
    Engine Oil
      If your mileage is less than 7,500 miles (12,000 km) yearly, replace the engine oil filter at each oil change.
    Distributor Cap
Clean/Repack
    Wheel Bearing
      Inspect and lubricate front wheel bearings. Also service when replacing disc pads. Clean and repack front spindle needle bearings.
Service or Charge
    Transfer Case
      Change lubricant.
    Manual Transmission/Transaxle
      Change lubricant.