Countergear & Shaft

1. Place gear case in upright position. Front bearing retainer/input shaft bore should be facing up.

Fig. 28 Countershaft & gear installation:

2. Slide countergear into position in case then install front bearing and bearing snap ring on countershaft.
3. Install countershaft in gear an seat shaft front bearing in case.

Fig. 29 Countershaft front bearing race installation:

4. Install countershaft front bearing race in case and on bearing.
5. Install snap ring that retains countershaft front bearing race in case bore.
6. Install countershaft front bearing cap in case bore. Apply Mopar adhesive/sealant or equivalent to bearing cap before installation.
7. Install rear bearing on countershaft, then bearing retaining snap ring.