Flow Testing Procedure

1. Disconnect the transaxle inlet cooler line at the transaxle, place the line in an empty gallon container.

2. Shift the transaxle into neutral, start engine and run at curb idle for 20 seconds, while observing the fluid flow. If the flow is intermittent or it takes longer than 20 seconds to collect one quart of ATF, locate and replace the restricted cooler(s).

CAUTION: DO NOT FLOW MORE THAN ONE (1) QUART OF ATF OR INTERNAL DAMAGE MAY OCCUR.


3. If fluid flow is within the acceptable limits, connect the transaxle cooler line to the transaxle and fill it to the proper level.