Single Air Pump

Drive Belt Locations:

AIR INJECTION PUMP

Loosen the air pump lock screw and pivot screw, and insert a 1/2" drive extension into the hole provided in the air pump housing bracket. If belt cannot be adjusted tight enough, then the belt must be replaced.




BELT DEFLECTION METHOD

Warning: Belts must be checked with engine not running.

1. Locate the half-way point between two pulleys.
2. Apply a 10 pound push or pull load on the belt with a small spring scale.
3. Measure the deflection of the belt while under the ten pound load.
4. The deflection should be between 1/4" and 5/16" for all belts.

Note: The deflection of a new belt should be between 1/4" and 1/2". A belt is considered used after 15 minutes of operation on a vehicle.