Oil Pump Replacement

REMOVAL

Oil Pump Assembly:

Remove two (2) screws holding oil pump to cylinder block assembly.

INSTALLATION
1. Apply Mopar Gasket Maker to pump body-toblock interface (machined surface).
2. Lubricate oil pump rotor & shaft and drive gear.

Crankshaft And Intermediate Shaft Timing:

3. Thrn crankshaft and intermediate shaft until markings on sprockets are in line (see arrows).

Oil Pump Shaft Alignment:

4. Slot in oil pump shaft must be parallel to center line of crankshaft when intermediate shaft and crankshaft are properly timed.

Oil Pump Assembly:

5. Install pump full depth and rotate back and forth slightly to ensure proper positioning and alignment through full surface contact of pump and block machined interface surfaces.

CAUTION: Pump must be held in fully seated position (described above) while installing screws.

6. Tighten screws to 23 N-m (200 in. lbs.).