Removal/Installation

1. Remove skid plate, if equipped, and drain transfer case.
2. Disconnect speedometer cable or sensor wire, indicator switch electrical connector, then the parking brake cable guide from pivot, if necessary.
3. Disconnect vacuum switch hoses, if equipped.
4. Disconnect input and output shafts then support and position shafts aside.
5. Disconnect transfer case shift lever from range lever.
6. Support transmission with suitable jack.
7. Support transfer case with a suitable jack. Chain transfer case to jack.
8. Remove transfer case to transmission attaching bolts, then move transfer case assembly rearward until free of transmission output shaft.
9. Lower jack and remove transfer case from under vehicle.
10. Reverse procedure to install.