Electronic Component Handling
STATIC DISCHARGE1. Discharge any static electrical charges before handling electronic parts by touching ground or maintaining a ground connection to a bare skin area like the wrist.
2. Never touch the engine controller connector pins, integrated circuit connector pins, or soldered components on the engine controller circuit board.
TESTING
1. When measuring voltage at the control unit harness connector, disconnect harness connector with the ignition OFF, then turn ignition "ON" as necessary.
2. To prevent deforming control unit harness connectors, do not probe terminals directly. Instead, insert a pin from the harness side and perform measurements through pin.
ENGINE CONTROLLER DAMAGE
1. Do not try to disassemble any Engine Controller.
2. Before performing electrical welding (for instance, spot welding), disconnect the battery, climate control, injection, cruise control, Engine controller and radio.
3. If temperatures may exceed 176°F (80°C), (example: infra-red spray booth), remove all controllers.
4. Avoid getting water on any of the Fuel and Engine Control System Components.
5. Never apply battery power to a component unless directed to do so in a test procedure.