Pressure Bleeding

When bleeding ABS systems use only diaphragm type bleed pressure bleeder.

1. Turn ignition switch to Off position, then pump brake pedal a minimum of 40 times to de-pressurize hydraulic accumulator.
2. Attach bleeding equipment to brake reservoir.
3. Connect a suitable transparent hose to bleeder valve on left rear wheel cylinder and submerge other end in a glass container partially filled with clean brake fluid.
4. Turn pressure bleeder On, open brake bleed screw 3/4 to one turn. Allow brake fluid to flow until clear and bubble free.
5. Continue to bleed right rear, left front, then right front brakes in that order.
6. Turn Off pressure bleeder, then slowly bleed off pressure from equipment.
7. Remove pressure bleeder from vehicle, ensure proper fluid level in master cylinder.