Fuel Pump Replacement

1. Depressurize fuel system as follows:
a. Disconnect battery ground cable, then remove fuel filler tube cap to release fuel tank pressure.
b. Remove protective cap from pressure test port on fuel rail.
c. Using hose from fuel gauge/hose tool set No. 5069 or equivalent, place gauge end of hose into approved gasoline container.
d. Place shop towel under test port, then screw other end of hose to fuel test port.
e. After fuel pressure has been released, remove hose and install test port cap.
2. Drain fuel tank, then remove from vehicle.
3. Disconnect fuel module fuel lines and electrical connectors.
4. Remove fuel pump module locknut. Fuel pump module will spring up when locknut is removed.
5. Remove module from fuel tank.
6. Reverse procedure to install.