California

Throttle Position Switch Circuit:

To test the Idle Switch, located on the throttle body, proceed as follows.

COMPONENT TEST
1. Disconnect the Throttle Position Sensor connector.
2. With the throttle closed, use an ohm meter and check for continuity between terminal 3 and ground.

Continuity
Should exist.

3. Open the throttle approximately 50%, use an ohm meter and check for continuity between terminal 3 and ground.

Continuity
Should not exist.

HARNESS TEST:
1. Disconnect the ISC connector and turn the key to the ON position.
2. Using a voltmeter, check the voltage between the harness connector terminal 4 and ground.

Voltage:
4 - 5 volts.

3. Turn the key OFF, disconnect the negative battery cable and the ECM Connector.
4. Using an ohm meter, check for continuity between ECM harness terminal 72 and ISC harness terminal 4.

Continuity
Should exist.

5. Using an ohm meter, check for continuity between ECM harness terminal 72 and ground.

Continuity
Should not exist.



If any of the previous tests produce unsatisfactory results, the harness will need to be repaired or replaced. Once repairs have been completed, road test the vehicle to confirm that the repair has corrected the problem.
If the same problem reoccurs, it is possible that there is an intermittent failure of the component or the ECM. Check for looseness at all harness junctions and test for an intermittent failure.