Input Shaft

DISASSEMBLY
1. Verify that the 3-4 synchronizer is in the neutral position.

Separtate Input And Output Shafts:

2. Separate input shaft from output shaft.

Remove Output Shaft Pilot Bearing:

3. Remove the output shaft pilot bearing from the input shaft or output shaft.

Input Shaft Components:

4. Remove the fourth gear synchronizer ring from the input shaft.
5. Remove the select fit snap-ring holding the input shaft bearing onto the input shaft.
6. Using Bearing Splitter P-334 and a shop press, remove the bearing from the input shaft.

ASSEMBLY
1. Position input shaft bearing onto input shaft. Be sure that the snap-ring groove in the bearing is facing forward.
2. Using Driver 6052, drive bearing onto input shaft.

Select Input Shaft Bearing Snap-Ring:

3. Select the thickest snap-ring that will fit into the snap-ring groove of the input shaft.
4. Lubricate output shaft pilot bearing bore of input shaft with petroleum jelly.
5. Install output shaft pilot bearing in input shaft bore.
6. Install the fourth gear synchronizer ring onto the input shaft.
7. Install input shaft to output shaft.