Headlamp Switch: Service and Repair

The headlamp switch is part of the left pod switch assembly.
1. Fabricate a 3/16 inch diameter metal rod approximately 10 inches long. Bend 1 1/2 inches on both ends 90°.
2. Place fabricated tool in hole right of switch in cluster bezel below the pod switch assembly, then depress lower tab and pull switch free of lower tab.
3. Move tool upward right side of switch to top tab, then pull tab down and pull switch out of bezel.
4. Disconnect wire connector.
5. To install, connect wire connector and push switch into until tabs lock.