Installation

Lower Ball Stud Installation:

1. Press new ball stud in lower suspension arm with Remover/Installer C-4212.
2. Position new seal over ball stud. Use a socket to force retaining lip of seal until securely locked in place.
3. Position steering knuckle on ball studs. Install ball stud retaining nuts. Tighten lower nut to 183 N.m (135 ft. lbs.). Tighten upper nut to 142 N.m (105 ft. lbs.) and install new cotter pins.
4. Remove spring compressor tool and install shock absorber.
5. Install the disc brake caliper.
6. Install the wheel and tire assembly.