Transfer Shaft

DISASSEMBLY

Rear Cover Bolts:

Remove Or Install Rear Cover:

Remove Transfer Shaft Gear Retaining Nut:

Transfer Shaft Gear Nut And Washer:

Remove Transfer Shaft Gear:

Transfer Shaft Gear And (Select) Shim:

Using Tool L-4406-1 With Adapter L-4406-3, Remove Transfer Shaft Gear Bearing Cone:

Install Transfer Shaft Gear Bearing Cone:

Governor Support Retainer:

Remove Governor Support Retainer Bearing Cup:

Install Governor Support Retainer Bearing Cup:

Low/Reverse Band Anchor Pin:

Governor Assembly:

Transfer Shaft Bearing Snap Ring:

Remove Transfer Shaft And Bearing Retainer Assembly:

Remove Or Install Transfer Shaft And Bearing Retainer Assembly Using Tool L-4512:

Transfer Shaft And Bearing Retainer:

Remove Transfer Shaft Bearing Cone:

NOTES:
- Remove old sealant before applying new sealant. Use Mopar RTV sealant, or equivalent, when installing cover.

- Remove or install both governor valves and governor body.

DETERMINING SHIM THICKNESS
Shim thickness need be determined only if any of the following parts are replaced:
- Transaxle case
- Transfer shift
- Transfer shaft gear
- Transfer shaft bearings
- Governor Support retainer
- Transfer shaft bearing retainer
- Retainer snap ring
- Governor support

Refer to Bearing Adjustment Procedure to determine proper shim thickness.

Install Transfer Shaft Bearing Cone:

Remove Transfer Shaft Bearing Cup:

Install Transfer Shaft Bearing Cup:

Tighten Transfer Shaft Gear Retaining Nut To 271 Nm (200 ft. lbs.):

Checking Transfer Shaft End Play:

ASSEMBLY
To install transfer shaft, reverse the above procedure.