Headlamp/Fog Lamp Alignment -- Using Alignment Screen

Headlamp Alignment Screen:

1. Position vehicle on a level surface perpendicular to a flat wall 7.62 meters (25 ft.) away from front of headlamp lens.
2. If necessary, tape a line on the floor 7.62 meters (25 ft) away from and parallel to the wall.
3. From the floor up 1.27 meters (5 ft), tape a line on the wall at the centerline of the vehicle. Sight along the centerline of the vehicle (from rear of vehicle forward) to verify accuracy of the line placement.
4. Rock vehicle side-to-side three times and allow suspension to stabilize.
5. Jounce front suspension three times by pushing downward on front bumper and releasing.
6. Measure the distance from the center of headlamp lens to the floor. Transfer measurement to the alignment screen (with tape). Use this line for up/down adjustment reference.
7. Measure distance from the centerline of the vehicle to the center of each headlamp being aligned. Transfer measurements to screen (with tape) to each side of vehicle centerline. Use these lines for left' right adjustment reference.

HEADLAMP ADJUSTMENT
A properly aimed low beam headlamp will project the center of the low beam hot spot on the alignment screen 229 mm (9 in.) ±5O mm (2 in.) below the headlamp centerline. The center of the hot spot should be 100 mm (4 in.) ±5O mm (2 in.) right of the headlamp centerline. The high beams on a vehicle with aero headlamps cannot be aligned. The high beam pattern should be correct when the low beams are aligned properly.

Headlamp Bubble Level And Adjusters:

To adjust headlamp alignment, rotate alignment screws to achieve the specified low beam hot spot pattern.






BUBBLE LEVEL CALIBRATION (VERTICAL AIM)
After the headlamp alignment has been verified or set and the bubble level is not centered, calibrate the bubble level.

NOTE: Any calibration of the headlamp bubble level must be done on a level surface and the headlamp cool. Do not operate the headlamps for a minimum of 20 minutes prior to beginning adjustments.

1. Remove screws holding magnifying window to top of headlamp module.
2. Position magnifying window to the side between headlamp module and radiator closure panel.
3. Through slotted hole in magnifying window, insert small screw driver into bubble level calibration screw.
4. Rotate screw in proper direction until bubble is centered on the "0".
5. Install magnifying window, making sure "O" ring is in place.
6. If necessary calibrate magnifying window.


MAGNIFYING WINDOW CALIBRATION (HORIZONTAL AIM)

After the headlamp alignment has been verified or set and the magnifying window is not centered, calibrate the magnifying window.
1. Loosen screws holding magnifying window to top of headlamp module.
2. Using the calibration knob above headlamp lens, rotate magnifying window until window is centered over the "0" on the gauge below the window.
3. Tighten screws to hold magnifying window to headlamp module. Do not over-tighten.






FOG LAMP ALIGNMENT
Prepare an alignment screen. Refer to the Alignment Screen Preparation paragraph. A properly aligned fog lamp will project a pattern on the alignment screen 100 mm (4 in.) below the fog lamp centerline and straight ahead. To improve visual interpretation of the fog lamp pattern on the alignment screen, disable the headlamps by disengaging the wire connectors from the headlamp bulbs.