Compressor HVAC: Service and Repair

Fig 14 Compressor Removal/Installation:

The compressor may be removed and repositioned without disconnecting the refrigerant lines or discharging the refrigerant system. Discharging is not necessary if servicing the compressor clutch or clutch coil, the engine, the cylinder head, or the generator.

WARNING: Review the Service Precautions before performing the following operation.

REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Loosen and remove the serpentine drive belt.
3. Unplug the compressor clutch coil wire harness connector.
4. Recover the refrigerant from the refrigerant system.
5. Remove the refrigerant lines from the compressor. Install plugs in, or tape over all of the open refrigerant fittings.
6. Remove the compressor mounting bolts, and lift the compressor from the mounting bracket.

NOTE: If a replacement compressor is being installed, be certain to check the oil level.

INSTALLATION
1. If the compressor mounting bracket was removed, install the bracket to the engine. Tighten the mounting bolts to 27 N.m (20 ft. lbs.).
2. Install the compressor on the mounting bracket. Tighten the bolts to 41 N.m (30 ft. lbs.).
3. Remove the tape, or plugs from all of the refrigerant fittings. Install the refrigerant lines on the compressor.
4. Install the serpentine drive belt.
5. Plug in the compressor clutch coil wire harness connector.
6. Connect the battery negative cable.
7. Evacuate and charge the refrigerant system.