Extension Housing and PTO Cover

1. Apply bead of MOPAR Gasket Maker, or equivalent, to mating surface of extension housing. Keep sealer bead width to maximum of 3/16 inch. Do not use excessive amount of sealer as excess could be displaced into oil pump.
2. Position extension housing over output shaft.
3. Spread extension housing retaining ring and seat extension housing on rear case. Verify that the retaining ring is seated in output shaft rear bearing.
4. Install retaining ring access cover.
5. Apply MOPAR silicone sealer, or equivalent, to threads of extension housing bolts. Then install bolts finger tight.
6. Tighten extension housing bolts to 27 - 34 Nm (20 - 25 ft. lbs.) torque.
7. Install speedometer adapter.
8. Apply MOPAR silicone adhesive/sealer to mating surface of PTO cover and to cover bolt shanks and underside of bolt heads. Then install and tighten bolts to 27 - 34 Nm (20 - 25 ft. lbs.) torque.