Overdrive Installation

1. Inspect the gasket to make sure it was not damaged during removal. If damaged, refer to the service manual for replacement.

2. Install the thrust bearing and spacer in overdrive unit sliding hub. Use petroleum jelly to hold it in place.

3. Carefully slide the alignment tool 6227-2 out of the unit.

4. Raise the overdrive unit and carefully slide it straight onto the intermediate shaft.

5. Install the attaching bolts and tighten the bolts to 34 Nm (25 ft lbs) in a diagonal pattern.

6. Install the transmission mount and tighten to 41 Nm (30 ft lbs).

7. Connect speed sensors and speedometer wires.