Reverse Band Adjustment

1. Remove the plug in the rear servo test port.





2. Based on the measurement taken in step 7 of REVERSE BAND LEVERS AND STRUT REPLACEMENT select the appropriate size drill bit from the table:

3. Insert the butt end of the appropriate drill bit into the test port 3 inches deep and centered beneath the servo plug.

4. With the bit properly located, tighten the reverse band adjusting screw to 8 Nm (72 in lbs) and back off the screw 2 1/4 turns.

**5. Loosen the adjusting screw and repeat step 4. While holding the adjusting screw, tighten the adjusting screw lock nut to 34 Nm (25 ft lbs).**

6. Remove the drill bit and replace the rear servo test port plug.