Bucket Seat Cushion Cover
BUCKET SEAT CUSHION COVERREMOVAL
NOTE: Cloth trim is bonded to the cushion foam.
Fig. 3:
1. Remove the anchor bolt attaching the seat belt to the seat track (Fig. 3).
2. Remove seat.
3. Remove the screw attaching the recliner handle to the recliner mechanism.
4. Remove seat side shield and disconnect wire harness.
5. Disengage the rearward J-straps.
6. Disengage both side J-straps.
7. Disengage the front J-strap.
8. Disengage hook and loop fasteners.
9. Separate the cushion/cover from the frame.
INSTALLATI0N
1. Install anti-squeak sheet.
2. Position the cushion/cover on the frame.
3. Engage the front J-strap.
4. Engage the side J-straps.
5. Engage the rearward corner J-straps.
6. Engage hook and loop fasteners.
7. Engage the rear J-strap.
8. Install the recliner handle.
9. Install seat. Tighten the front seat track bolts to 22-34 N.m (16-25 ft. lbs.). Tighten the rear seat track bolts to 89-140 N.m (66-103 ft. lbs.).
10. Install the anchor bolt attaching the belt to the seat track and tighten to 40 N.m (29 ft. lbs.).