General Information

GENERAL INFORMATION
Each vehicle is equipped with various lamp assemblies. A good ground is necessary for proper lighting operation. Grounding is provided by the lamp socket when it comes in contact with the metal body, or through a separate ground wire.

When changing lamp bulbs check the socket for corrosion. If corrosion is present, clean it with a wire brush and coat the inside of the socket lightly with Mopar Multi-Purpose Grease or equivalent.

SYSTEM OPERATION
Daytime Running Lamps
The daytime running lamps are controlled by the Daytime Running Lamp Module (DRLM). The DRLM is located in the engine compartment on the left fender wheelhouse. The DRLM allows the high beam headlamps to illuminate at a reduced intensity when the engine is running with the headlamp switch OFF. The Daytime running lamps will go out when the headlamp switch is turned to the headlamps on position. The passing light feature will flash bright high beams while the daytime running lamps are activated.