Instrument Panel End Cap Replacement

REMOVAL AND INSTALLATION

The end cap on the driver side end of the instrument panel also conceals the junction block and serves as the fuse access panel.

Instrument Panel End Cap Remove/Install:

1. Remove the instrument panel end cap by grasping it firmly using the finger recess molded into the cap.
2. Pull the end cap sharply away from the end of the instrument panel to release the snap clips that secure it there.
3. To install the instrument panel end cap, align the snap clips on the back of the end cap with the snap clip receptacles in the end of the instrument panel. Then, push in firmly on the end cap over each of the snap clip locations until it snaps back into place.