Instrument Cluster Bezel Replacement

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIRBAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Turn the ignition switch to the Unlock position, set the parking brake, and place the automatic transmission gear selector lever in the Low position.
3. If the vehicle is so equipped, set the tilt steering column in its lowest position.

Cluster Bezel Remove/Install:

4. Using a trim stick or another suitable wide flat bladed tool, gently pry around the perimeter of the cluster bezel to disengage the snap clip retainers that secure the bezel to the instrument panel.

CAUTION: Be certain to use care when removing or installing the cluster bezel so as not to damage the trip odometer reset button, which extends through the lens near the outboard side of the instrument cluster. If the trip odometer reset button is damaged, the instrument cluster unit must be replaced.

5. Pull the outboard side of the cluster bezel away from the instrument panel far enough to clear the trip odometer reset button.
6. Remove the cluster bezel from the instrument panel.
7. Reverse the removal procedures to install.