Glove Box Replacement

REMOVAL

WARNING: ON VEHICLES EQUIPPED WITH AIRBAGS, REFER TO AIR BAGS AND SEAT BELTS/AIR BAGS BEFORE ATTEMPTING ANY STEERING WHEEL, STEERING COLUMN, OR INSTRUMENT PANEL COMPONENT DIAGNOSIS OR SERVICE. FAILURE TO TAKE THE PROPER PRECAUTIONS COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND POSSIBLE PERSONAL INJURY.

1. Disconnect and isolate the battery negative cable.
2. Open the glove box.

Glove Box Remove/Install:

3. While securing the glove box door with one hand, push the center of the glove box bin towards the front of the vehicle. Flex the glove box bin far enough so that the glove box stops on each side of the bin will clear the sides of the instrument panel glove box opening.
4. Roll the glove box downward until the stop bumpers are beyond the sides of the instrument panel glove box opening, then release the bin.
5. Lift the bottom of the glove box upward to disengage the three glove box hinge hooks from the three hinge pins on the instrument panel.
6. Reverse the removal procedures to install.