System Specifications

Tighten the four screws that secure the instrument cluster to the instrument panel to 2.2 N.m (20 in. lbs.) torque.

Tighten the seven screws that secure the lens and hood unit to the cluster housing to 2.2 N.m (20 in. lbs.) torque.

Tighten the six screws that secure the rear cover to the back of the cluster housing to 2.2 N.m (20 in. lbs.) torque.

Tighten the four screws that secure the lower reinforcement to the instrument panel to 2.2 N.m (20 in. lbs.) torque.

Tighten the two screws that secure the inside hood latch release handle to the instrument panel lower reinforcement to 2.8 N.m (25 in. lbs.) torque.

Tighten the two screws on the left, and one screw on the right that secure the instrument panel center support bracket to the Airbag Control Module (ACM) bracket on the floor panel transmission tunnel to 11.8 N.m (105 in. lbs.).

Tighten the two screws that secure the center support bracket to the instrument panel to 11.8 N.m (105 in. lbs.) torque.

Tighten the four screws that secure the upper edge of the lower bezel to the instrument panel to 2.2 N.m (20 in. lbs.) torque.

Tighten the two screws that secure the lower edge of the lower bezel to the instrument panel to 2.2 N.m (20 in. lbs.) torque.

Tighten the five screws that secure the top of the instrument panel to the top of the dash panel to 3.2 N.m (28 in. lbs.).

Tighten the right and left instrument panel cowl side roll-down bracket screws to 11.9 N.m (105 in. lbs.).

Tighten the nut that secures the instrument panel wire harness radio ground eyelet to the stud on the right cowl side inner panel to 3.9 N.m (35 in. lbs.).

Tighten the screw that secures the instrument panel wire harness ground eyelets to the left side of the Airbag Control Module (ACM) mount on the floor panel transmission tunnel to 3.4 N.m (30 in. lbs.).

Tighten the screw in the center of the connector to 3.5 N.m (31 in. lbs.).

Tighten the two screws that secure the inside hood latch release handle to the instrument panel lower reinforcement to 2.8 N.m (25 in. lbs.).

Tighten the screws around the perimeter of the top cover that secure it to the instrument panel base to 2.2 N.m (20 in. lbs.).

Tighten the screw that secures the demister duct tee to the instrument panel. Tighten the screw to 2.2 N.m (20 in. lbs.).

Tighten the screw that secures the flexible demister tube to the demister duct tee, and remove the tube from the tee to 2.2 N.m (20 in. lbs.).

Tighten the two screws that secure the passenger side airbag module lower bracket to the instrument panel to 11.8 N.m (105 in. lbs.).