Bucket Seat Removal
BUCKET SEATREMOVAL
NOTE: If vehicle is equipped with center seat/console, remove seats and console as one assembly.
1. If equipped, remove side shield and disengage power seat switch connector.
2. Move seat to full forward position.
Fig. 2:
3. Remove rear screws attaching trim cover to seat track (Fig. 2).
4. Remove rear bolts attaching rear seat track to floor pan.
5. Move seat to full rearward position.
6. Remove front screws attaching trim cover to seat track (Fig. 2).
7. Remove front bolts attaching front seat track to floor pan.
NOTE: Do not actuate recliner or track adjuster once bolts are removed.
8. Tilt setback forward and lift seat out through door.
INSTALLATION
1. Position seat in vehicle.
2. Install bolts attaching front seat track to floor pan.
Tighten bolts in sequence:
a. Driver's seat:
1. Front outboard
2. Front inboard
b. Passenger's seat:
1. Front inboard
2. Front outboard
c. Bucket seat with center seat (40/20/40)
1. Driver's front outboard
2. Passenger's front inboard
3. Driver's front inboard
4 Passenger's front outboard
3. Tighten bolts attaching front seat track to floor pan to 28 N.m (20 ft. lbs.).
4. Install front screws attaching trim cover to seat track.
5. Move seat to full forward position.
6. Install bolts attaching rear inboard seat track to floor pan and tighten to 40 N.m (30 ft. lbs.).
7. Install bolts attaching rear outboard seat track to floor and tighten to 28 N.m (20 ft. lbs.).
8. Install rear screws attaching trim cover to seat track.
9. If equipped, engage power seat switch connector and install side shield.