P1763 Governor Pressure Sensor Volts Too High

SYMPTOM
P-1763B GOVERNOR PRESSURE SENSOR VOLTS TOO HIGH

WHEN MONITORED
Continuously with the key on and engine running.

SET CONDITION
The voltage from the Governor Pressure Sensor is above 4.89 volts for 8.5 seconds.

POSSIBLE CAUSES
- Trans harness/solenoid def (sig ckt > 5.0 ohms)
- PCM defective (gov pressure sensor volts too high)
- Trans harness/solenoid def (gnd ckt > 5.0 ohms)
- Governor press sensor signal ckt shrt to voltage
- Governor pressure sensor ground circuit open
- Governor pressure sensor signal circuit open
- Governor pressure/temperature sensor def
- Trans harness/solenoid def (sig ckt > 1.0 volt)
- No possible causes remaining
- 5-volt supply circuit open
- Transmission harn/sol assy defective (gnd res)
- Governor pressure/temperature sensor def
- PCM defective (gov pressure sensor volts too high)
- Powertrain control module defective
- Transmission harn/sol assy defective (sig res)